General
566 results found
-
Add real-time behavior to step function
The unit step function always transitions at t=0. A voltage source defined as v(t) = 5(t)u(t) very nicely steps to 5V at t=0, however, v(t) = 5(t)u(t-3) should transition at t=3 but it behaves incorrectly.
1 vote -
fix the flow of electricity in the app.
The yellow electrons are always flowing from the positive (5V) leads to the negative (ground) lead. This is the opposite of how energy flows in real life and is extremely misleading to the users. To fix this, all you need to do is multiply the direction by -1.
4 votes -
6 votes
-
isolated circuits with isolated grounds
I want to use an op-amp circuit to measure the voltage across the resister of another circuit. Unfortunately both circuits by default use the same ground reference, so I am unable to simulate it.
8 votes -
Build/add electrical and motor control circuits for electricians, and PLC
Build/add electrical and motor control circuits for electricians, such as single-4pole switches. Push button start/stopbuttons normally open/close relays/contacts, single and 3 phase AC motors, float switches, pressure switches, Logic controls, limit switches, control circuits...
14 votes -
transient analysis
Would be great to see the transient response of the circuit before becomes stable and the response is continuous, a precise scope just to capture that.
3 votes -
4 votes
-
1 vote
-
Non delivery of purchased product
Give people that purchase it the install files so they can actually use it.
1 vote -
Add solenoids and other components
I’d like to see solenoids. There are a few other parts I’d like to have. But that would be a great start. I recently attempted to sketch out the RPC system in a 2300 series P&H electric wire rope shovel from work.
1 vote -
Add forward current to LEDs
Because LEDs don’t have a set forward voltage, finding a good resistor value can be difficult. Also, it means that you can have values like GIGA-AMPS flowing through your LEDs and circuits. That could probably be fixed by having them break and pause the simulator.
6 votes -
What about the shiftOut fuction
I really need it tho try some things with the 74HC595.
4 votes -
Add Boolean Logic to Expressions
Returns a value of 0 or 1
bool(x > y)
bool(element.V > 1.3)1 vote -
Scope improvement: XY mode or VTC
Add a mode to the scope that allows you to draw a graph with one voltage on the x axis and the other on the y axis. This is super useful for things like voltage transfer characteristics, Schmidt triggers and other things like that.
12 votes -
We need interconnects.
Interconnects are essential for my usage. I love the app. But more switches and interconnects would be really helpful.
1 vote -
Transformers configuration
The ability to configure transformer input and out put with voltage entry for trappings.
8 votes -
Addition of other arduino boards
Addition of other Arduino boards to add to circuits Mega, Nano ,Yun etc.
16 votes -
希望操作更方便
建议加入指针，用手滑手机屏幕时，指针可以顺着手滑屏幕的方向移动。类似于鼠标操作
1 vote -
Allow an initial condition to be set for a component such as a capacitor starting off charged before thé simulation is run.
I havé à circuit that firstly charges a capacitor then fires off thé charge to opérateur a latching solénoïde. However, on thé second firing stage, i néed to be able to set thé capacitor as having a potential différence across its plates.
2 votes -
6 votes
- Don't see your idea?