Skip to content

Ryan Hart

My feedback

2 results found

  1. 144 votes
    Vote

    We're glad you're here

    Please sign in to leave feedback

    Signed in as (Sign out)
    You have left! (?) (thinking…)
    21 comments  ·  General  ·  Admin →
    How important is this to you?

    We're glad you're here

    Please sign in to leave feedback

    Signed in as (Sign out)
    An error occurred while saving the comment
    Ryan Hart commented  · 

    Yes, tubes please! Perhaps a few of the most common ready to use, and then if I could customize them by filling in parameters from data sheets, then I could basically have everything I need without (I suspect) too much dev work.

    Ryan Hart supported this idea  · 
  2. 294 votes
    Vote

    We're glad you're here

    Please sign in to leave feedback

    Signed in as (Sign out)
    You have left! (?) (thinking…)
    48 comments  ·  General  ·  Admin →
    How important is this to you?

    We're glad you're here

    Please sign in to leave feedback

    Signed in as (Sign out)
    Ryan Hart supported this idea  · 
    An error occurred while saving the comment
    Ryan Hart commented  · 

    I work with tubes a lot, and while I don't need the simulation to be incredibly accurate (hard to simulate tubes as accurately as transistors), being able to simulate tube circuits would help me get close a lot faster. The two models included aren't nearly enough. Directly heated triodes, for example, have heater current on the cathode. I'd like to simulate a hum cancelation circuit for that.

Feedback and Knowledge Base